Back to 9000 Series Home
               

+  More Images

9000 Series modules are not compatible with module ports in existing 900 Series, 700 Series or BG-M Series mixer/amplifiers.

The only recommended 900 Series Modules to be used with the 9000 Series products are the Signal Modules: S-01S, S-02S, S-04S and S-20S.

Note: The maximum number of S-20S modules supported by the 9000 Series main frame depends on the serial number. Units manufactured before and including 07H are limited to (2) two of the S-20S modules. Units manufactured after and including 07I are limited to (4) four of the S-20S modules.

 

	D-001T Dual Mic/Line Input Module with DSP Two Balanced Mic / Line Inputs Digital Signal Processing 10-Band Parametric EQ Bass / Treble Loudness High and Low Pass Filters Compressor Adjustable Sensitivity (nine levels, -60 to -10 dBV) Phantom Power (24 VDC) Removable Terminal Block Maximum four per chassis Required for VOX (Voice-Operated Switch) function and input level metering CAD Specification   (DWG, 52kb)
	T-001T Dual Line Output Expansion Module with DSP Two Balanced Line Outputs Digital Signal Processing 10-Band Parametric EQ Bass / Treble Loudness High and Low Pass Filters Compressor TOA speaker EQ presets Removable Terminal Block Maximum three per chassis CAD Specification   (DWG, 68kb)
	D-001R Dual Unbalanced Line Input Module with DSP Two Unbalanced Line Inputs with Stereo Summing RCA jacks Digital Signal Processing 10-Band Parametric EQ Bass / Treble Loudness High and Low Pass Filters Compressor Adjustable Sensitivity (nine levels, -60 to -10 dBV) Maximum four per chassis Required for VOX (Voice-Operated Switch) function and input level metering   CAD Specification (DWG, 60kb) Instruction Manual (PDF, 38kb)
	C-001T Input/Output Control Module Eight assignable control inputs for activating Event, Volume Up/Down (Input or Output), Mute (Input or Output), Power On/Off, Emergency Mute or Synch On/Off Eight assignable control outputs for activating external relays Removable Terminal Block Maximum one per chassis CAD Specification (DWG, 72kb)
	ZP-001T Telephone Zone Paging Module Telephone Access Paging to up to eight zones Uses DTMF dialing to access amplifier and/or line outputs Dial up to eight output zones in one operation Analog extension or page port compatible Page port operation requires contact closure activation RJ-11 Telephone Jack and Removable Terminal Blocks Maximum one per chassis CAD Specification (DWG, 81kb)
	AN-001T Ambient Noise Controller Module  Automatically adjusts output gain to compensate for changes in ambient noise level Each input can be assigned to control a specific output Two inputs with +24VDC phantom power for condenser mics 14 preset gain ratios Accessory sensing microphone available, model AN-9001 Maximum two per chassis CAD Specification (DWG, 52kb)